Other symptoms
The receiver keeps outputting a “Searching…” message, and the NETWORK LED is
blinking
:
It should take up to one minute to establish a wireless link. If the link was not
established after one minute, verify the transmitter is powered on and not connected to
another receiver.
The receiver is outputting “Connected to source name, Please Check Video
Source”
:
Check the HDMI connection between the transmitter and the video source.
The receiver displayed a connection failure message and outputs a “Wireless Off”
message
:
If there is more than one registered transmitter, and the receiver failed to
connect to it within a minute or two, the receiver will go into standby mode and shut down
the RF. In order to connect to the desired source, press on the “SOURCE” button and
chose the desired source.
The NETWORK LED flashes rapidly and there is no display on the monit
or:
Power
cycle the unit. If the issue remains, the device might be faulty. Please contact
team.
support
Link cannot be established or poor video/Audio quality
:
Try to decrease the range
between the transmitter and the receiver or remove obstacles from the way between the
transmitter and receiver.
