Registering without remote control
If there is no transm er registered to the receiver, you should see an OSD menu on the
monitor.
1.
Power down any pre-registered receiver to prevent any video transmission during
the registra on process.
2.
Connect the HD Source to the transmi er (the registra on process can be done
without HD source in which case an OSD message will appear to no y of missing
video source).
3.
Connect a HDMI cable from the receiver to the HD display, for OSD guidance.
4.
Power up the transmi er and receiver.
5.
Long press for 10 seconds the Registra on bu on on the Rx [#12], un
he
“Network” LED starts blinking.
6.
The OSD message “Please
te the Registra on on Transmi er Unit” will appear
on the monitor.
7.
Press the Registra on bu on [#10] on the Tx un the “Network” LED starts blinking.
8.
Wait for OSD message of "Adding [Tx name] Press OK to con nue or Exit to cancel".
9.
Press the Registra on bu on [#12] on the Rx to con
fi
rm.
10.
Wait un the registra on process has completed. OSD message of " Adding [Tx
name]…"and progress bar will be shown during the process.
11.
Video link is established.
Note: The en re registra on process may last up to 3 minutes.
Registering a t
receivers
The transmi er has the ability to connect up to 4 receivers at a me.
1.
There is a need to make sure the transmi er is not transm
g video to other
receivers, so all other receivers which are registered to the transmi er should be
powered down while registering an add onal receiver.
2.
Connect the HD Source to the transmi er*.
3.
Using HDMI cables connect each receiver to a HD display.
4.
Power on the transmi er and receiver.
5.
Power on only one receiver at a me for ease of install on.
6.
Use the remote control at the receiver and Press the “
Add
” Hotkey bu on.
7.
The message “
Please Ac vate the Registra on on Transmi
Unit
” will appear on
the monitor.
8.
Pressing the registra on bu on on the transmi er un
“
Network
” LED starts
blinking.
9.
Wait for OSD message of "
Adding
[
Tx name
]
Press OK to con nue or Exit to cancel
".
10.
Press the “OK” bu on on the IR Remote to con
fi
rm the add on of the receiver.
