T3500 Plus Tethered Power System for Drones
Operation Caution
©
2019 FOXTECH All Rights Reserved
6
1.；Pull out the cable 3~5m, suitable for the drone
The screen shows the value of the released cable. It cannot be used as the flight altitude.It’s just the
length of released cable.Considering the bending state during the flight, the cable can extend up to
106m.
2.；Connect the cable jack-plug to the onboard
power input port.
3；Attach the hook to the carbon plate reserved
port or other force bearing point.
4.；Connect onboard power output end to the
drone battery interface.
The installation requirements of onboard power supply are specified in the technical specification.
should not be too close to carbon plate, The onboard power supply module must be connected with
the winch cable connector first, then power on. Otherwise it will ignite and burn the onboard power
chip, which is not covered by the warranty.
