VDC-30 Long Range Video/Data/RC Wireless Transmission System
User Manual
©
2020 FOXTECH All Rights Reserved
10
VDC-30 Instruction
Quick Start
1.Preparing
Make sure all the connections are ready, including the antenna, Ethernet cable and so on.If you connect a
ethernet gimbal to VDC-30 air unit, the GH1.25 interface is recommended for high reliability.
2.Power on
The DC voltage is 9~28V. After power on, the POWER LED will be solid green.
Any question, please refer to the FAQ. It takes 15 seconds to start up. After the system starts, the wireless
transmission can be established.
3.Using PC to get video from ethernet gimbal.
Connect gimbal
×
VDC-30 and PC as shown above
×
Attention×Please ensure that gimbal and PC on the same network segment. The default IP of VDC-30 is
in the table below. The network segment of gimbal and M52 can be different. VDC-30 can transparently
transmit video and data.
VDC-30 air unit default IP
192.168.1.200
VDC-30 ground unit default IP 192.168.1.236
Get video
U s e r c a n g e t v i d e o i n P C t h r o u g h
the software provided by the gimbal
manufacturer.
Also, user can use some common software
such as VLC. Take VLC for an example.
In the “open media” page, please input the
following address× rtsp://192.168.1.36:554/
stream0
You can get video after click “play”.
