Foxtech MX16 Pro, User Manual

Page: 64 / 68

NAGA PRO User Manual
60
configuration debugging\standard parameters, don't check the board voltage, and others can be
checked or unchecked. Remove the check,then remember to click the "Write Parameters"
button above, then power off the flight controller and reconnect it).
5. Compasses inconsistent solution
The cause of the problem:
Compasses inconsistent means that the compass is out of sync.
When we use the dual compass, if the GPS arrow and the flight controller arrow are not
consistent, this error will be reported.
Solution: When using dual compass: fix the GPS, the GPS arrow and the flight controller
arrow are consistent. The simplest solution is to only use an external compass (that is, GPS
compass)
6. NO RC receiver
The cause of the problem:
The signal input of the receiver is abnormal.
Solution: If you are using the PPM encoder board, check whether the blue status light of the
PPM encoder is still flashing (you can judge whether the PPM encoder is still working). If
using SBUS and PPM receivers, check whether the receiver settings are correct.
7. RC not calibrated
The cause of the problem:
the remote controller has not been calibrated, or the range is not
within the recorded value of the flight controller. it is usually caused by setting the remote
controller or changing the remote control.
Solution:
Re-calibrate the remote controller.
8. Compass not healthy
The cause of the problem:
The electronic compass is unhealthy. It may also be that there is
no value or the hardware is damaged. It may also be that the ambient temperature is lower than
0, which may cause the compass sensor to have no value.
Solution: Power on again. If the temperature is too low, please take heat preservation
measures. Power on again, and check whether the compass values of MX1 MY1 MZ1 \MX2
MY2 MZ2 are correct at the ground station-Status.
9. Compass not calibrated
The cause of the problem:
the compass is not calibrated, or the compass is removed and
added, it will prompt that the compass is not calibrated.
Solution:
After installing the compass, do the calibration again.