Foxtech Argus V3, User Manual

Page: 9 / 23

DJI PSDK Installation
1. Position the Argus V3 SKYPORT adapter ring at the bottom of the DJI psdk
interface。
2.
Install SKYPORT adapter ring with white dot mark corresponding to interface red
dot mark, and rotate Argus V3 to connect red dot mark of adapter ring to complete
installation.
Installation of quick mounting pan tilt
1. Fix the Argus V3 quick mount pan tilt on the bottom of the aircraft and lock it
with screws。
2. Press the buttons on both sides of the pan tilt mount.
3. The top connector of Argus V3 pushes the hook into the empty slot of the
mount, and releases the buttons on both sides of the mount to complete the
hook.
4. Adjust the tilt and the position of the aircraft center of gravity by tightening the
screws of Argus V3 pan tilt.
Before flight operation, check that Argus V3 has been correctly installed on
the Argus V3 at the aircraft end, and adjust the center of gravity to ensure
that the Argus V3 quick mount latch pops up and is stuck into the hole of
the quick mount plate.
Be sure to adjust the center of gravity when Argus V3 is not powered and
the fuselage is stable.
Use Argus V3
Power on state
After the power supply is connected, the power indicator light of the fuselage is
always on, the status indicator of each camera will automatically detect and flash
once, and once again when the detection is completed. When the indicator lights of
each camera are off, the camera will enter the working state.
Pull out the power supply connector to enter the shutdown state, and all indicator
lights are off.