Foxfury Lighting Solutions 200-800, Product Manual, Page: 14 / 20

14
INSTALLING THE BATTERY TUBES | 30 MINS
Installing the Nomad
®
Battery Tubes follows the same procedures as removing
them but in reverse order.
1. Start with the bottom of the Battery Tube. Attach the black Cap to the
NEGATIVE end of the Tube. While holding the Cap in place, reinsert it into
the Battery Compartment, at an angle.
2. While still applying downward pressure to the Battery Tube, attach the red
Cap to the opposite POSITIVE end of the Tube. Once secure, slide the
Tube into place in the Battery Compartment.
IMPORTANT: Be sure to place the red and black wires directly
behind the Battery Tube before re-installing the Tube into the Battery
Compartment. This will prevent the wires from being damaged, and it
will help the Battery Tube go back into place easier.
3. Once the Battery Tube is installed, test the Nomad
®
to make sure it turns
ON. If it does not, check the Battery Tubes for any connection errors with
the positive (+) and negative (–) ends. Then, place the Battery Cover back
over the Battery Tube and tighten the four (4) screws into place.
2
3
1
WARNINGS
Be sure to check polarity (positive (+) and negative (–)) when installing the
Battery Tubes.
!
BATTERY TUBE PLACEMENT WHILE INSTALLED
(HORIZONTAL VIEW)
TO
P
RED CAP
(PO)
BLACK CAP
(NEGATIVE –)