HARDWARE INSTALLATION
9
front Panel Header : fP1
This motherboard includes one header for
connecting the front panel switch and LED
Indicators.
Hard Disk LeD Connector (HDD-LeD)
Connect to the chassis front panel IDE
indicator LED. It indicates the active status
of the hard disks. This 2-pin connector is
directional with +/- sign.
Reset Switch (ReSeT-SW)
Attach the connector to the Reset switch on
the front panel of the case; the system will
restart when the switch is pressed.
Power LeD Connector (PWR-LeD)
Connect to the power LED indicator on the
front panel of the chassis. The Power LED
indicates the system’s status. When the
system is in operation (S0 status), the LED
is on. When the system gets into sleep mode
(S1) , the LED is blinking; When the system
is in S3/S4 sleep state or power off mode
(S5), the LED is off. This 2-pin connector is
directional with +/- sign.
Power Switch Connector (PWR-SW)
Connect to the power button on the front
panel of the chassis. Push this switch allows
the system to be turned on and off rather than
using the power supply button.
Serial ATA Connectors : SATA_1/2
The Serial ATA connector is used to connect with
SATA Hard Disk or CD devices which support this
feature. The SATA_2 allows up to 3GB/s
data transfer rate, the SATA_1 support SATA
3.0 specification, and allows up to 6GB/s data
transfer rate.
TPM Header : TPM
The TPM (Trusted Platform Module) provides the
ability to the PC to run applications more secure
and to make transactions and communication
more trustworthy. To utilize this function, you
should purchase additional device and install it.
HDD-LED
RESET-SW
NC
+
-
PWR-SW
+
-
PWR-LED
EMPTY
1
2
10
9
FP1
LCLK
LFRAMEn
LRESETn
LAD3
VDD
LAD0
3D3V_DUAL
NC_1
GND
LPCPDn
GND
EMPTY
LAD2
5V_SYS
LAD1
GND
NC_4
SERIRQ
CLKRUNin
NC_5
1
2
19
20
TPM
GND
TX+
TX-
GND
RX-
RX+
GND
1
SATA_2
GND
TX+
TX-
GND
RX-
RX+
GND
1
SATA_1
