3
39
PC Health Status
► Warning Temperature
This option is used to set the warning temperature for the system. When the temperature of
CPU is higher than the set value, the motherboard will send out warning information.
► Shutdown Temperature
This item is used to set the system temperature upper limit. When the temperature exceeds
the set value, the system will shut down automatically.
This function works only when your operating system is supporting ACPI.
► Case Open Warning
This item is used to enable or disable case open warning function.
► CPU/System Temperature
The CPU/System temperature are automatically detected and displayed by the system.
► CPU/System Fan Speed
The CPU/System fan speed are automatically detected and displayed by the system.
► CPU Core/DRAM V3.30V/+5.00V/+12.0V
The current voltages are automatically detected and displayed by the system.
► CPU Smart Fan/System Smart Fan Control
This option is used to enable or disable smart fan function.
The following 4 settings are valid only when Smart Fan Control is set to [Enabled].
► Fan OFF Temperature
It allows you set a temperature value from which smart fan stops its operation.
► PWM Start Temperature
It allows you set a temperature value from which smart fan starts its operation.
► Start PWM Value
It allows you to set an initial PWM value to drive the fan when the temperature reaches Start
value and smart fan begins its operation. The higher PWM value can achieve the faster fan
speed.
► Slope PWM Value
The slope controls the PWM value being stepped up or down versus temperature changes
CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
PC Health Status
Warning Temperature
[Disabled]
Help Item
Shutdown Temperature
[Disabled]
Case Open Warning [Disabled]
CPU Temperature
:32
o
C/89
o
F
System Temperature
:27
o
C/80
o
F
CPU Fan Speed
:2109 RPM
System Fan Speed
:N/A
CPU Core
:1.152 V
DRAM Voltage
:1.596 V
+3.30V
:3.264 V
+5.00V
:4.858 V
+12.0V
:12.513V
CPU Smart Fan Control
[Disabled]
System Smart Fan Control
[Disabled]
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[Disabled]
Options
