Terrier T200 LSA Flight Manual Rev No.: 1.0 15 April 2008
Page 11 of 31
6.2 Before Starting Engine
1
Pre-flight Inspection
COMPLETE
2
Seatbelts & Harness
ADJUST & LOCK
3
Fuel Shutoff Valve
Both ON
4
Radio/Intercom
OFF
5
Brakes
TEST & SET
6
Set Instruments
Instruments SET
6.3 Starting Engine – Cold Engine
1
Carburettor Heat
OFF
2
Choke
ON
3
Throttle
25%
4
Fuel Boost Pump
ON
5
Propeller Area
CLEAR
6
Master Switch
ON
7
lgnition Switches
ON
8
Joystick
FULL BACK
9
Start Button
PRESS
10
Check all engine instruments for function
11
Choke
CLOSED after warm up completed
IMPORTANT:
Check the engine oil pressure. If you do not see oil pressure within 10 seconds, shut down
the engine immediately and check the cause.
6.4 Starting Engine -Hot Engine
Proceed as for cold engine above, but choke to be closed
6.5 Warm-Up and Functional Check
Warm-up the engine with a fast idle of 1500 -2000 RPM until the oil temperature reaches 50 degrees C.
During this phase, the cooling is insufficient due to reduced airflow. It is therefore advisable not to shorten
the warm-up time by running the engine at higher RPM. The aircraft should be pointed into wind to allow
additional cooling air. As soon as the oil reaches 50° C, it is possible to do the run-up.
