7320 IFL Installation and User’s Guide
Set Up
Foxcom Proprietary Information
13
Document No. 93-005-28-C
3.1.1. Setting Up the Transmitter
1.
Place the 7320T in the 7000M Chassis. The operating base plate
temperature must be between -10
°
C to 55
°
C.
2.
Apply AC power to the chassis. The Power Supply’s LED should be lit.
3.
Mount the 7320T into the chassis. The Laser LED should be lit.
4.
Using an optical power meter, measure the optical power. Insert the meter’s
cable into the Transmitter’s optical connector. Power levels should be
between 0.3 - 1 mW.
Alternatively, use a DVM to measure the voltage at pin #6 on the back panel
connector. The power level should be -4.5
±
0.3 VDC.
5.
On the rear panel, connect the coax cable to the RF Input Connector.
6.
On the rear panel, connect the fiberoptic cable to the Optical Connector.
Note
If either LED is not lit, refer to Trouble Shooting on page 24.
