50
12. Position the support plate (
78
) in order that it touches lightly the saw blade.
13. Tighten the screw (
79
) firmly.
14. Re-assemble the workbench.
15. Lock the rip fence’s rail.
DANGER!
Before performing any adjustment or maintenance task and before changing the
blade you must switch off the machine, disconnect it from the power supply and wait
for the saw blade to stop.
I. General regulations
In case you find out any damage to the protection devices or irregularities while processing or
checking the machine, you must get it repaired immediately by qualified persons.
Before use check that the protection and safety devices are perfectly efficient. After carrying
out the work, make a general cleaning of the machine by removing dust and chips.
Do not use any thinner to clean plastic pieces. Most of the kinds of plastic risk to get damaged
by commercially available thinners. Use a clean cloth to remove impurities, dust, etc.
Extract periodically sawdust that can pile up inside the machine by opening the two doors.
Clean also the ventilation inlets of the engine.
Be sure that the protective cap can slide freely.
Periodically check the tensioning and the conditions of the belt.
Periodically check the conditions of the flywheels’ coatings.
Periodically check bench inlay’s conditions.
II. Replacement of the flywheels’ coatings
Regularly check the flywheels’ coatings and if necessary
change both of them:
1. remove the saw blade (see previous paragraphs);
2. let a small screwdriver slide under the coatings and
remove them;
3.
place the new plastic coatings and re-assemble the saw
blade.
III. Replacement of the bench inlay
The bench inlay must be changed when the hole for the passage of the blade is damaged.
1. remove the bench inlay (
80
) from the workbench by pushing from below.
2. Insert a new bench inlay.
MAINTENANCE
