P/n: 605-00-060, rev . d |
2006 FLOAT x EVOL OwnEr’s mAnuAL
9
sTEp 2
Align the top edge of the roost guard against the piggyback body cap . the bottom of the
roost guard should overlap the edge of the air sleeve by a minimum of 1/8" . if the guard
does not overlap the edge of the air sleeve by the minimum requirements, slide it down
the shock body until it does . the guards should be mounted on the fronts of the shocks
taking into account left and right orientations .
ensure thAt roost guArds Are instAlled such thAt they do not
touch the eVol Air chAmber or inhibit trAVel.
minimum 1/8"
sTEp
Place a block or a jack under the front of the frame so that both wheels are off the
ground .
sTEp
remove stock shocks from the vehicle . note location of spacers, etc . save the bolts, nuts,
washers, etc ., as you will use these with your new floAt X evol Airshox .
the pArt number for your pArticulAr floAt x eVol shock
is engrAVed on the bAck side of the body cAp eyelet.
AdditionAl setup instructions specific to your Vehicle Are
included on A supplementAl sheet included with this mAnuAl.
the mounting orientAtion specific to your Vehicle is Also
included with the supplementAl setup sheet.
Summary of Contents for FLOAT X EVOL
