SEATING, TABLES AND ADDITIONAL BEDS
Depending on which model and options you have in your recreation vehicle, seating will include some
combination of the following:
•
SOFA
- The sofa will comfortably seat three adults. It also converts to a bed by lifting the front section
and pulling toward you. The sofa back follows and pivots down into a prone position. To reconvert back
to a sofa, lift the front and push back and down into place. The sofa back will follow and pivot up into its
upright position automatically. When reconverting to the sofa configuration, make sure to pull the seat
belts out to their usable positions.
•
J-LOUNGE SOFA
- The J-Lounge will seat 3 adults, and by using the built in seat belts, can be used
while in transit.
•
RECLINER
- The recliner operates just like a standard household recliner. By pulling the footrest lever,
the footrest will extend. Since a seatbelt is not provided on the recliner it is not to be used while in
transit.
•
DINETTE
-
Wall Mounted Type Dinette - Lift the aisle side of the table and unhook from sidewall and
swing into place. The table supports on the dinette base.
Pedestal Type Dinette (Optional)
- The dinette can also be converted into an additional
bed if required, to convert, lift the table top off of the two support posts. Remove the
support posts from the floor and lay them down between the seats. Insert the table top
between the seats on the ledges provided. Loosen the seat cushion from the velcro
fasteners and slide together to form the bed. Reverse this process when reconverting to
the dinette configuration.
•
FOLD-DOWN LOUNGE TABLE
- This table is stored in a folded position next to the lounge chair. To
raise for use, pull out on the bottom to release it from its securing catch, and swing up. When raised
reach under the table and swing the supporting leg down until it locks into position. Adjust the length of
the support leg, so that the table will be level when resting on it. To adjust the support leg length, pull
back on the spring clip, releasing the detent from the adjustment hole it is presently in. While holding the
spring clip back, slide the leg to the desired length, then release the spring, allowing the detent to lock
into the new hole. To fold back for storage, reverse the previous procedure; shortening the support leg,
and folding the leg up against the bottom of the table top. Lower the table top and push in on the bottom
to secure it into catch that keeps the table from moving while traveling.
•
FREE STANDING DINETTE CHAIRS
- Some models have free standing dinette chairs. Since these
chairs are not permanently attached to the floor, and not equipped with seat belts, they should not be
occupied while the recreation vehicle is in motion. These chairs should be stored securely while the
vehicle is in motion.
Mandalay
12-9
Summary of Contents for 2005 Mandalay
