FOUR WINDS INTERNATIONAL
CONTROLS AND OPERATIONS
43
Programming The User Code
Note:
The default user code is "54321"
Note:
This mode will only retain the last 4 remote transmitters programmed. If the
transmitter memory is exceeded, the security system will start deleting transmitters
from memory in chronological order.
1. Enter the program code "12345" on the keypad. The beeper will emit a long chirp to confirm
the correct code was entered.
2. Enter a new 4 to 6 user code on the keypad. Do not use "1234".
3. Finish by pressing the LOCK key on the keypad. 1 long beep with 2 short beeps will confirm
the new user code has been stored into memory.
4. If you have additional user codes (up to 4) that need to be programmed, repeat steps 2 and 3
for each new user code.
Exit:
Press and hold the LOCK key for 1 second or if 15 seconds of inactivity occurs during the above steps,
the unit will revert back to the last successfully stored code. 3 long beeps confirm exit.
Note:
For complete operational instructions, please consult the owner's manual provided
for this product.
AUTOMATIC HYDRAULIC POWER LEVELERS
With any hydraulic application, holding position on a cylinder must be done with safety
in mind. Failure in the system may cause the leg(s) to retract or extend on its own.
When working under or near the motor home, always use jack stands of appropriate
rating to support the weight of the motor home.
Read the entire operators manual and all precautions prior to operating this equipment.
Do not use the jacks to change the tires. The system is designed as a leveling and stabilizing system and is
not meant to lift the motor home off the ground.
Do not operate any system functions while anyone is under the motor home.
Do not attempt to operate the system while the motor home is in motion.
Never place hands or other parts of the body near hydraulic leaks. Oil may penetrate skin causing severe
injury. Wear safety glasses when inspecting or servicing the system to protect eyes from dirt, metal chips, or
leaks, etc. Follow all other applicable shop safety practices.
The motor home should be parked on a fairly level surface. Ensure that there are no obstructions in the extend
or retract paths of the jacks. If the surface is soft due to saturation or heat, place boards under the jacks to
distribute the weight over a larger area. Using a board which measures approximately 2' wide by 2' in length
is recommended. Ensure the front tires are pointing forward and not to the left or right.
Note:
Refer to manufacturer’s operations manual before operating.
The automatic hydraulic power leveling system allows quick and easy leveling of the motor home from
the driver’s seat by utilizing the system touch panel. The following instructions are general operating
instructions.
