Four-Faith F7 34 Series, User Manual

Page: 32 / 92

F7X34 Series Router
User Manual
Xiamen
Xiamen Xiamen
Xiamen Four-Faith
Four-Faith Four-Faith
Four-Faith Communication
Communication Communication
Communication Technology
Technology Technology
Technology Co.,Ltd.
Co.,Ltd. Co.,Ltd.
Co.,Ltd.
Page 32 of 92
Add
：
J1-J3,3
rd
Floor,No.44,GuanRiRoad,SoftWare Park,XiaMen .361008.China
http
：
//www.fourfaith.com Tel
：
+86 592-6300326 6300325 6300324 Fax
：
+86 592-5912735
Bridging-Create Bridging-Create Bridging-Create Bridging-Create Bridge Bridge Bridge Bridge:::: creates a new empty network bridge for later use. STP means Spanning
Tree Protocol and with PRIO users are able to set the bridge priority order. The lowest number has
the highest priority.
Bridging
Bridging Bridging
Bridging ---- Assign
Assign Assign
Assign to
to to
to Bridge
Bridge Bridge
Bridge::::
allows users to assign any valid interface to a network bridge.
Consider setting the Wireless Interface options to Bridged if they want to assign any Wireless
Interface here. Any system specific bridge setting can be overridden here in this field.
Current
Current Current
Current Bridging
Bridging Bridging
Bridging Table
Table Table
Table:::: shows current bridging table
Create
Create Create
Create steps
steps steps
steps as
as as
as below:
below: below:
below:
Click 'Add' to create a new bridge, configuration is as below:
Create bridge option: the first br0 means bridge name. STP means to on/off spanning tree
protocol. Prio means priority level of STP, the smaller the number, the higher the level. MTU
means maximum transfer unit, default is 1500, delete if it is not need. And then click 'Save' or
'Add'. Bride properties is as below:
Enter relewant bridge IP address and subnet mask, click 'Add' to create a bridge.
Note: Only create a bride can apply it.
Assign to Bridge option: to assign different ports to created bridge. For example: assign port
(wireless port) is ra0 in br1 bridge as below:
Prio means priority level: work if multiple ports are within the same bridge. The smaller the
number, the higher the level. Click 'Add' to take it effect.
Note: corresponding interface of WAN ports interface should not be binding, this bridge
function is basically used for LAN port, and should not be binding with WAN port