OPERATING INSTRUCTIONS
Page 5
Filling the Sprayer
WARNING: RISK OF DEATH, PERSONAL INJURY AND/OR PROPERTY DAMAGE FROM IMPROPER CHEM-
ICAL USE OR MIXTURE. Never use flammable or combustible liquids, caustics, acids, or hot water in
this Sprayer. Spraying flammable or combustible liquids can create combustible fumes that could be
ignited by the electrical system in the Sprayer, causing an explosion. Always refer to chemical manu-
facturer instructions for proper mixture. Always wear appropriate personal protection equipment
as instructed by chemical manufacturer when using, preparing, handling, spraying, or disposing of
chemicals. This includes at least goggles, gloves, and protective clothing.
CAUTION: RISK OF DAMAGE TO INTERNAL COMPONENTS. Use of chemicals other than water based
or water soluble solutions may damage the Sprayer and will void the warranty.
1. Ensure that the Pump is turned OFF (Light is OFF).
2. Pull up on the knob of the Pressure Release
Valve until all the pressure is released from the
tank
(See Figure G)
.
2. Turn the Pump handle counterclockwise to
remove the pump
(See Figure H).
3. Fill the Tank to the desired level. See fill markings
on side of Tank. (Always refer to chemical
manufacturer for proper mixture).
4. Install the Pump into the Tank opening and turn
clockwise until tightly sealed against the Tank
(See Figure I).
Figure I
Figure H
Figure G
Powering-On and Spraying:
WARNING: RISK OF UNINTENDED SPRAYING AND CHEMICAL EXPOSURE. Ensure that the Shut-off
is in the closed position (Lever released) before pressing the Power Button. The Sprayer will spray
if the Shut-off is open (Lever depressed) when the power is turned ON. Only spray when the air is
calm (no wind or air movement) to prevent chemical spray from drifting into unintended areas.
