2
Recommended Blocking:
Wood double stud blocking is necessary. Contact an architect
complies with building codes (
Fig. a
).
2. Locate wood stud where left side of changing station will be mounted to
the wall.
3. For
A. D. A.
compliance, measure up 43” (109 cm) from the floor and mark
the wall. This locates the position for the top left attachment hole.
NOTE:
Mark on wall MUST be in center of wood stud.
4. Lay top section of changing station down on changing station bed
(Fig. c)
and
align hole in top left corner of changing station with mark on wall and hold in place.
5. Using a level and measuring tape, mark the remaining three (3) holes. After marking
holes, set changing station down on ground.
6. Use a power drill and appropriate bit to drill four (4) holes in the wall. This may require
2 people.
NOTE 1:
For wood studs:
-
a 7/32” masonry bit for the pilot hole until you hit the wood
stud, then change to 1/8” bit.
-
(Fig. d)
.
NOTE 2:
For use with toggle anchors:
-
has metal studs, or has an underlying surface of concrete block,
use 1/2” bit.
-
(Fig. e)
.
- For holes NOT located in a wood stud, toggle anchors MUST be
used
(Fig. f)
. See “Using Toggle Anchors” section.
7. Rotate plastic top section back up so that mounting hardware goes through
the plastic as well as the metal back
(Fig. b)
.
NOTE:
(Fig. g)
.
8. Align holes in changing station with drilled holes and secure top left corner of changing
station to wall stud using the appropriate screw and washer. Continue to secure the
three (3) remaining corners using the appropriate screws and washers as described
in
Note 1
or
Note 2
.
INSTALLATION
Fig. b
Truss Head
Spanner Screws
Fig. c
Surface-Mount
Holes
Fig. f
Fig. e
Toggle
Anchor
Flat
Washer
Changing
Station
Machine
Screw
Wood Stud
Fig. d
Changing
Station
Finishing
Washer
Wood
Screw
Wood Stud
Flat
Washer
Fig. a
Fig. g
Collar
Unit
Wall
1. Use #14 Spanner bit to remove and discard Truss Head Spanner screws
from unit back
(Fig. b)
.
8 1/4
(210 mm)
on center
32"
(813 mm)
on center
Top
For A. D. A.
Compliance
43”
(109 cm)
