To prevent damage to the product or injury to you or to others, read the
following safety precautions in their entirety before using this equipment.
Keep these safety instructions where users can read them for ready reference.
To avoid overheating & damaging your flash unit, please wait for about three minutes
after 30 times continuous triggers at full power.
Do not disassemble or modify
There are high-voltage components inside the unit. Failure to observe this precaution
could result in electric shock or product malfunction. Should the product break open
as the result of a fall or other accident, send the defective back to authorized service
center for inspection and maintenance.
For Your Safety
Caution
Foreword
For Your Safety
Caution
Names of Parts
Operations
Technical Data
Maintenance
Body
Accessories
Flash Preparation
Power Connection
Flash Output Control
Test Button
Sync Triggering
Slave Trigger Model
Modeling Lamp
Tube Replacement
Buzz Function
Thank you for your purchase of Studio Flash.The device is designed for photo-
graphers seeking studio equipments in good quality at an affordable price.
With its well-chosen key components and parts, the product is of high quality, stability
and reliability for all portrait, fashion, wedding art, advertisement photography and
video shooting etc.
The unit comes with a Bowens Mount ring that can accept any Bowens compatible
softbox.
.
01
02
02
03
03
03
04
04
04
04
04
04
05
05
05
05
06
06
Foreword
Contents
02
Keep dry
Do not handle with wet hands or immerse in or expose to water or rain. Failure to
observe this precaution could result in fire or electric shock.
Keep out of the reach of children
This device contains small parts that may pose a choking hazard. Consult a physician
immediately if a child swallows any part of this device.
Do not expose to high temperature
Do not leave the device in a closed vehicle under the sun or in other areas subject to
extremely high temperature. Failure to observe this precaution could result in fire or
damage to the housing or internal parts.
Do not keep long time in using the modeling lamp, otherwise the modeling lamp will
be deformed, and the flammable accessories such as softbox will get burnt. The flash
can be used at full power for five minutes continuous, and then it should be cooled
down one minute.
When using a snoot, do not keep long time the modeling lamp on or over frequent
flashlight (not over six times for one minute). Overheating will result in damages for
strobe housing and studio light.
Do not touch the lamp cap when the flash or modeling lamp is working, as it will give
out heat, leading to high surface temperature.
Avoid sudden impacts as this can damage the flash tube and/or modeling lamp.
01
