-7-
-8-
■
Switch Panel and Function Description
OPERATION
1.Plug into power point and switch on rangehood.
2.Pull out the rangehood panel .
3.Press the right switch “ ” and the lamp will light up. press the “ ”
The lamp will be off.
4.Press the left switch “ ”, the rangehood will operate on low speed.
5.Press the “ ”, the rangehood will operate on high speed.
6.Press the “ ”, the rangehood will be turned off.
Be sure to power off the appliance before cleaning or maintenance. For example,
. Cut off power socket.
. pull the power plug out of the socket on the wall and move away the plug.
Cleaning and Maintenance
■
Metal filter
Notes for Cleaning:
1) The metal filter can be used repeatedly. It should be frequently cleaned (at least once
every three or four weeks) so that it may prevent the grease accumulation. Too much
grease may cause a fire.
2) When mounting or dismounting the metal filter screen step by step, make sure the screen
is held by hand all the time, so that it will not fall off and break or damage the items below.
3) Immerse the filter screen into hot water, put proper detergent inside and wash it with a soft
brush. Or put it into the dishwasher for cleaning.
4) Never use anything hard or high-corrosive detergent to clean it; more attention should be
paid to avoid the deformation.
■
Carbon filter
■
Replacing notes
1. When it fails to remove the kitchen smells or has been used for more than six months,
please replace the carbon filter or carbon particles.
2. When mounting or dismounting the metal filter, make sure the filter is held by hand all the
time, so that it will not fall off to break or damage the items.
■
Metal or glass surface
Use soft cotton cloth and neutral detergent for cleaning; it is strongly advised to use special
cleaning detergent to protect the external surface of your appliance.
■
Switch
1. The electric elements and display elements of the switch tend to be corroded and fade
under long-term oil environment and require more careful cleaning.
2. It should be cleaned with soft cloth and neutral detergent. The cloth should be wrung out
before cleaning to prevent short circuit and corrosion of the switch lines.
■
Change the light
1. Rotate the light cover to dismount it, pull out the lamp along its pointing direction. Mount
on the new light in reverse direction.
UPA6001
UPA9001
Set the carbon filter into the relavant buckle along the direction of 1,then following the direction
of 2 to push down and rotate.
2
1
2
1
2
