Instruction manual
START and USE
Coffee Machine
Page 21 of 28
Before starting the appliance, check the tools supplied
with the same and described in this manual.
1.
Take the tank, rinse
and fill with fresh
water.
2.
Refilled the tank,
and
after
having
closed
with
the
stopper containing
the charging hoses,
place it inside its
compartment.
!
Fill the tank always and only with water at ambient
temperature and not carbonated. Hot water or other
liquids may damage the tank and the machine.
!
When you first start the appliance, delivering at least
two cups of hot water (from the compartment using
the special pods disc supplied with the machine) to
allow complete filling of the hydraulic circuit.
First start
Open the left side panel
to access the main switch
to position ON (1).
The machine is in the heating phase, the LEDs light up
and the coffee button flashes.
!
The appliance can be brought in stand-by, in this
condition the machine is off, it works just the push-
button controls, while groups coffee and steam and
the led lighting does not feed.
We can stop the appliance from the control with on-
off button, the leds turn off and the keypad is
illuminated at low intensity.
In the case of empty tank, or low level of water,
the light "empty tank" will flash, and will not be
enabled any type of dispensing;
Quando il serbatoio è riempito di nuovo,
l'apparecchio
tornerà
al
suo
normale
funzionamento, e l'indicatore luminoso smette di
lampeggiare.
Loading of the hydraulic circuit
!
Before first use, or after long periods of inactivity, if
the water tank has been completely emptied it is
necessary to prime the circuit of the appliance.
In addition, the circuit must be loaded if flashes the
indicator of the empty tank , so as to eliminate any air
bubbles.
To load the circuit, make a dispensing without pods,
closing the drawer and press the brew button. Wait
until the group enters under pressure (about 8
seconds) and stop the dispensing.
To verify that the charging circuit has been carried out
correctly, press the hot water button and wait for the
water drainage from the spout (directing the spear out
of a cup or on the drip tray).
When are finish the operations described above, the
machine is ready for use.
To brew coffee, hot water or steam, and properly use
the appliance, carefully follow the instructions below
in the following pages.
EN
