Getting Started
Kit content
Before you start using the watch, make sure the following items are in
the box:
• AC charger
• Charging clip
• The Caller ID watch
Charging
Make sure your watch
battery is fully charged.
Minimum charging time is 3 hours by AC power.
If the battery does not work properly it needs to be replaced by an
authorized service center.
To charge the battery
1. Connect the battery charger plug to the charging clip with the symbols
on the charger and clip facing in the same direction.
2. Connect the charging clip to the watch by opening the clip and sliding
it over the watch. Make sure that the contact pins of the cradle are
connected to the hole/gap on the back of the watch.
3. Connect the battery charger to the mains. The appears. Wait
approximately 2 hours or until the battery icon indicates charging is
complete.
. Pull out the charger plug.
Under normal conditions, you should be able to use the watch for at least
a week if the battery is fully charged.
Setting the time
To set the time
Gently pull out the crown
and rotate it to set the time.
Push the crown back in when
the time is set.
The Bluetooth® function
The Bluetooth® function makes wireless connection to your phone
possible.
The first time you turn the Bluetooth® function on, the watch enters
pairing mode.
You should turn the Bluetooth® function off, in sensitive areas like
airplanes or hospitals.
If the battery level is low, the Bluetooth® function is automatically
turned off. Turn the Bluetooth® function on again when the battery
is fully charged.
To turn the Bluetooth® function on
Press and hold the bottom key. appears.
The first time you turn the Bluetooth® function on, the watch
enters pairing mode. If you want to exit the pairing, press and hold
the bottom key.
°
¢Q
