L005613 FOS TV BICOLOR PANEL USER MANUAL L005613 FOS TV BICOLOR PANEL USER MANUAL
5. Press
ENTER
to save the setting;
6. Press
MENU/SET
button to back.
MENU
M
AP
LCD SHOW
Function Instruction
Operation of
Buttons
Supplementary
Instruction
T=xxxC
◆
The temperature of LED
bulb radiator in real time
(Celsius)
◆
If there is no this
temperature shows, means
the temperature sensor
failure
◆
If the value over 80,
please check the wind path
is normal or not
No Signal
Couldn't receive the DMX
512 signal
RX DMX
Received the DMX 512
signal
RX Slave
Slave mode
You only need
set a master
light, the slave
light will be
identified
automatically
You need pull off the
DMX signal from
console under
master/salve mode
Address
Address setting
Press
UP
,
DOWN
button
to set the
address you
need, then
press ENTER
Put bushing and chuck onto the cable.
Prepare cable as shown above. The power cable must is a three-conductor 2.5mm2 cable.
Insert the wire into the terminals and fasten the clamping device by a flat screw driver.
Push insert and chuck into housing (pay attention to the guiding keyway).
Fasten bushing.
The color-coding schemes and some possible pin identification schemes; if pins are not
clearly identified, or if you have any doubts about proper installation, consult a qualified
electrician.
R
ELAYING
P
OWER TO
O
THER
D
EVICES
The lightings can be linked in a chain by power cables which installed a blue and a
light-gray connectors on the two ends. The light-gray connector connects to the power out
socket of the first lighting, and the blue connector connects to the power in socket of the
subsequent lighting, and so on.
05
04
07
