10
Correct set up of the spliter.
• The puller 1200 must press against the flat face.
• Arms must be positioned as closest as possible to the piece to be pulled out.
• It is the C distance which must be almost equal to the B.
• In hose cnditions the pullers can work at the maximum force level.
Incorrect spliter set up.
• The 1200 pullers NOT in flat side position.
• Arms are too far off the piece to be pulled out. The C distance is much greater than the B.
• In this position the turning torque on the arm tip is multiplied by L.
• In this position one cannot reach the maxumum force.
• Monitor th spindle bending and stop pulling when excssive.
1200 in flat side operation
1200 on the tapered face
The puller 1200 does not press the flat face.
Avoid doing this so as not to bend the puller and make the
job difficult.
Summary of Contents for 00910
