This equipment must be accompanied by a translation of the instructions in the language or
languages of the country in which the equipment is to be used and by the instructions in the
original language before being put into service.
It is important that only cables of suitable types are used and that all fuses or overload
protection devices are of suitable rating.
It is important to take adequate safety precautions when installing or working on the unit to
ensure accident or injuries do not occur due to falling machinery or tools.
In situations where there could be a risk of injury, should any part of the assembly become
detached for any reason and fall, normal common sense safety precautions should be
employed. A strong safety chain between the camera pan shaft and the mounting surface is
recommended.
Before mounting the unit ensure that the mounting area is capable of supporting the unit
under all weather conditions. Ensure that the mounting point and fixings positions are
suitable to ensure the unit can be securely mounted.
Ensure that all fastenings are secure before leaving installation.
Use only the power sources indicated in this user guide.
Ensure that the product case is properly earthed and that earth-bonding connections are made
correctly to the mounting base of the unit.
To minimise the risk of an electrical hazard ensure that all electrical power is disconnected
before working on the unit. It is important to make sure that all electrical power is
disconnected at the source end.
Do not back drive the pan or tilt axis of the MIC-440 as this will damage the motor drive gear
chain and will invalidate the warranty.
Installation
The product contains no user serviceable parts and the should not be opened on site as this
will invalidate the certification
The installation method will depend on the site conditions and installation preferences but the
MIC-440 can work up to 25 meters from its power supply. This means that if the power
supply can be placed within a non-hazardous area within 25 meters of the MIC unit a
standard power supply can be used (see Fig 1).
FIG 1
MIC1-440 Instruction Manual Page 5 of 43 Issue 2
