Initial Set-up
The following guides you step by step through the initial set up of
the navigation system.
Firstly, remove the foil for protecting the device during transpor
tation from the display.
I. Charging the battery
Attention: It can be necessary to recharge the battery
for some time initially before it is possible to run through the
initial installation, according to the state of charging of the
battery installed.
Please pay attention to the following notes when handling the
battery:
The charging status display lights red until the navitation
system is charged. Do not interrupt the charging process before the
battery is fully charged. This may take a few hours. The navigation
system is fully charged if the charging display lights green.
Note: You can use the navigation system during the charging
process, but the power supply must not be interrupted during initial
set-up.
To fully charge the built-in battery, the external power source
(car adapter) should remain continuously connected to the device.
You can leave the main adapter connected, and this is very
handy for continuous operation.
