FortrezZ MIMO2+, User Manual

Page: 8 / 12

MIMO2+, Multiple Input
– Multiple Output
Module Technical Appendix
1080 Centre Rd. Ste C
Auburn Hills, MI 48326
www.fortrezz.com
Phone: (248) 481-7092
sales@fortrezz.com
Made in USA
072916
COMMAND_CLASS_CONFIGURATION (all parameters are one byte unsigned values or can be considered as a
commanded, signed value with an offset of -256)

Parameters 1 and 2 are for output Relays only.

Parameter 3-7 are for SIG1 input only

Parameters 9-13 are for SIG2 input only.

The 8-bit thresholds (for parameters 4-7 and 10-13) are used for determining triggering and represent
the upper 8 most-significant bits for comparison to the 12-bit Analog-to-Digital converted value with the
remaining lower 4 bits of threshold set to 0.
Configuration Command Class Parameters
PARAMETER DESCRIPTION DEFAULT VALUE
SIZE
(bytes)
POSSIBLE
VALUES
** Note: All configuration parameter values are 1 byte in size. This allows for unsigned values from 0 to 255,
signed values from -128 to 127, and in hexadecimal the range is 0x00 to 0xFF. If your Z-Wave controller uses
signed values, see the Calculating Threshold Values section below to learn how to convert values over 127 to
their signed numerical value.
1
REL1 Configuration

b7..b5: Input-to-Relay Mapping (REL1
Basic/Binary Switch commands ignored); see
Relay Mapping section below

b4..b0: Momentary latch count (resolution
100ms, 0=non-momentary)
5
(=00000101b)
No relay mapping;
moment. latch for
0.5s
1
-128..127
(0x00..0xFF)
2
REL2 Configuration

b7..b5 Input-to-Relay Mapping (REL1
Basic/Binary Switch commands ignored); see
Relay Mapping section below

b4..b0: Momentary latch count (resolution
100ms, 0=non-momentary)
5
(=00000101b)
No relay mapping;
moment. latch for
0.5s
1
-128..127
(0x00..0xFF)
3
SIG1 Multilevel Trigger Settings

b7: Trigger Between Thresholds (1=true)

b6: Periodic Sends (=0) or Send when Change-
of-Trigger (=1)

b5-b0: Periodic Send Interval for Lifeline (30s
resolution, 0=no periodic sends)
-88
(=10101000b)
Trigger between;
send every 20
minutes
1
-128..127
(0x00..0xFF)
4
SIG1 Lower Threshold, High (Unsigned value
must be less than Upper Threshold Low and
greater than Lower Threshold Low) -112
(Unsigned Value =
144)
1
-128..127
(0x00..0xFF)
5
SIG1 Lower Threshold, Low -128
(Unsigned Value =
128)
1
-128..127
(0x00..0xFF)
6
SIG1 Upper Threshold, High -1
(Unsigned Value =
255)
1
-128..127
(0x00..0xFF)
7
SIG1 Upper Threshold, Low (Unsigned value must
be greater than Lower Threshold High and less
than Upper Threshold High) -2
(Unsigned Value =
254)
1
-128..127
(0x00..0xFF)
8 (not used)