Fortress Technologies FJW70A11P, User Manual

Page: 10 / 11

No
washing
Abnormal
draining
Abnormal
spin
Troubleshooting of washing machine
List of faults and inspection
Faults
Inspection Items
No water
flows in
!
!
!
!
!
!
If the power is off or the fuse is burned .
If the water supply is cut off or the water pressure is too low.
If the inlet hose is connected improperly and the water tap is turned on.
If the filtering screen of inlet valve is blocked by dirt.
If the coil of inlet valve is damaged. (The slight electromagnetic
sound is phenomenon when the inlet valve is opened)
If the "Start / Pause" button is pressed after the power
switch on.
!
!
!
!
If the door lid is not closed.
If all clothes are piled at one side of barrel and there are too many clothes.
If the washing machine is not placed in a stable condition or is tilted.
(The ground is not flat).
If the motor belt is loosened.
Note: During the spinning process, if washing are piled at one side of the spin barrel,
it will cause unbalance of the spin barrel and resulting in striking. At this moment, the
built-in computer of the washer can detect this unbalance situation and will automatically
correct it ( fill in water Washing ). However, if the unbalance situation is not removed after
continuous three corrections, The user has to manually place the clothes inside the barrel
evenly.
When problems of the washing machine arise, please contact local service office or the
sales service department of our company and users should not dismantle the
washing machine without permission.
If the washer cannot function normally, or there are abnormity signals, please check and
correct as follows.
!
!
!
If the water drain hose is placed too high.
If the end of water drain hose is not connected to the collection tank.
If the internal rubber ring of the drainage valve is blocked by dirt.
!
!
!
!
If the power is off or the fuse is burned .
If the power supply voltage is too low.
If the water amount reaches the required water level.
(The washer will not work if the water amount does not reach the
required water level)
If it is set to "Preset" washing mode. (It will only start to work
at the preset time)
17
Malfunction display and solutions
When problems of the washing machine happen, please contact local service office or the
sales service department of our company and users should not dismantle the machine
without permission.
If the washer cannot function normally, and the abnormal indicator is shown on the
display window or the machine alarms, please check and correct as follows.
18
Technical specifications
220V / 50Hz Rated power supply
460W
Input power
7.0kg
Rated washing capacity
7.0kg
Rated spin capacity
X X 550 565 918mm
(W*D*H)
Overall dimensions
Water pressure
3
9
kg Gross weight
0.03MPa 0.8MPa -
Washing mode
New water flow
Draining mode
Spin mode
Centrifugal spin
Gravity drain
1. Cut off power and start it 5 minutes later.
2. After re-start, the problem still keep-in;
please report to repairing.
1. Turn on the water tap. 2. Hydraulic pressure is low,
increase inlet water amount.
Check if water drainage hose is placed
correctly. Clean the stem.
Display Causes Methods
Alarm for abnormal
water intaking.
Alarm for water drain has
not finished.
Alarm for lid not closed
before spin.
Alarm for the power cut
off failed.
Please close the door lid.
Report for repairing.
Alarm for water level sensor.
Alarm for reading EEPROM
failed.
Alarm for washing stay at
one side.
Placed the washing equably.
Report for repairing.
The power cut off automatically.
Please choose 220V power source. High voltage
protection
270 10V
≥