OTP and Proud Post: Cutting the ATR to length
• Measure the distance from the inside edge of the 2 posts. Measure the angle needed to make the ATR flush with the post.
• Mark the cut lines on the ATR , and cut the ATR to length, file the edges, and paint using the same steps as used for
cutting down a panel.
• When test fitting the ATR, place it on top of the spacers.
Do not
press the ATR down over the spacers. Removing the
ATR from the spacers can damage the ATR and spacers.
•
If you are installing a OTP Line Post, see the next page before permanently installing the ATR
• Make sure the inside of the ATR is clean before remove the backing of all of the double-sided tape on the ATR spacers.
• Using force, the ATR snaps down around the ATR spacer.
Cut Line
Cut Line
ATR should not go past
this point when test fitting
14/15
