Inserting a FortiSwitch-5003B board
Hardware installation
FortiSwitch-5003B System Guide
22
01-400-134822-20120216
http://docs.fortinet.com/
To insert a FortiSwitch-5003B board into a chassis slot
To complete this procedure, you need:
• A FortiSwitch-5003B board
• An ATCA chassis with an empty hub/switch slot
• An electrostatic discharge (ESD) preventive wrist strap with connection cord
1
Attach the ESD wrist strap to your wrist and to an ESD socket or to a bare metal
surface on the chassis or frame.
2
If required, remove the protective metal frame that the FortiSwitch-5003B board has
been shipped in.
3
Insert the FortiSwitch-5003B board into the empty hub/switch slot in the chassis.
4
Unlock the handles by squeezing the handle locks.
5
Open the handles to their fully open positions.
Do not carry the FortiSwitch-5003B board by holding the handles or retention screws.
When inserting or removing the FortiSwitch-5003B board from a chassis slot, handle the
board by the front panel. The handles are not designed for carrying the board. If the
handles become bent or damaged the FortiSwitch-5003B board may not align correctly
in the chassis slot.
FortiSwitch-5003B boards must be protected from static discharge and physical shock.
Only handle or work with FortiSwitch-5003B boards at a static-free workstation. Always
wear a grounded electrostatic discharge (ESD) preventive wrist strap when handling
FortiSwitch-5003B boards.
Unlock
Handle
To avoid damaging the lock, make sure you squeeze the handles fully to unlock them
before opening. The handles should pop easily out of the board front panel.
Handle
Alignment Pin
Open
Alignment Pin
Lock
Handle
