Hardware Install Guide for FortiScan
22
2
Seat each end piece in the front holes of the vertical rack flanges (1).
Figure 15:
Installing and removing the rails (round-hole racks)
3
Align each end piece to seat the pegs in the top and bottom holes of the first U (2).
4
Engage the back end of the rail until it fully seats on the vertical rack flange and the first
“tooth” on the latch locks in place. Repeat these steps to position and seat the front end
piece on the vertical flange (3).
5
To remove the rails, pull on the latch release button on the end piece midpoint and
unseat each rail (4).
To install the system into the rack
1
Pull the inner slide rails out of the rack until they lock into place (1).
2
Locate the three shoulder screws on one side of the system and lower them into the J-
slots on the slide assembly (2).
1
2
3
4
