Fortinet FortiGate-600C, Quick Start Manual, Page: 5 / 13

Caution
: SFP transceivers are static sensitive devices. Use an ESD wrist strap or similar
grounding device when handling transceivers.
Caution : Do not install or remove SFP transceivers while fiber-optic cables are still
attached. This can cause damage to the cables, cable connectors, and the optical
interfaces. It may also prevent the transceiver module from latching correctly into the
socket connector.
Note : Installing and removing SFP transceivers can shorten their useful life. Do not
install or remove transceivers more than is necessary.
To install the SFP transceivers:
1.
Ensure that you are properly grounded.
2.
Remove the caps from SFP cage sockets on the front panel of the unit.
3. Position the SFP transceiver module in front of the cage socket opening and ensure
that the SFP transceiver module is correctly oriented.
When the module is correctly oriented, the extraction lever will be level with the socket
latch.
Note : SFP cage socket orientation may vary. Ensure that the SFP transceiver module
is correctly oriented each time that you are inserting a module.
3. SFP Transceivers
4. Hold the sides of the SFP transceiver module and slide it into the cage socket until it
clicks into place.
Caution: Do not force the SFP transceivers into the cage slots. If the transceiver
does not easily slide in and click into place, it may not be aligned correctly or may be
upside down. If this happens, remove the SFP transceiver, realign it or rotate it and
slide it in again.
5. Press the module firmly into the cage socket with your thumb.
6. Verify that the module is latched correctly by grasping the sides of the and trying to pull
it out without lowering the extraction lever.
If the module cannot be removed, it is installed and latched correctly.
If the module can be removed, reinsert it and press harder with your thumb. If necessary,
repeat this process until the module is securely latched into the cage socket.
To remove the SFP transceivers:
1.
Ensure that you are properly grounded.
2. If applicable, disconnect the fiber-optic cable from the SFP transceiver module
connector and install a clean dust plug in the module’s optical bores.
3. Pull the extraction lever out and down to eject the module.
If you are unable to use your finger to open the lever, use a small flat-head screwdriver
or other similar tool to open the lever.
4.
Hold the sides of the SFP transceiver module and carefully pull it away from the cage
socket.
5. Replace the cap on the SFP cage socket and place the removed SFP transceiver
module into an antistatic bag.
Note : Follow proper fibre-optic handling procedures when installing and removing SFP
transceivers to ensure the devices remain clean and are not damaged.
Extraction Lever
Transmit
Optical Bore
Receive
Optical Bore Socket Latch
SFP Cage Sockets