Installing Hard Drives
FortiAnalyzer-2000B Version 4.0 MR1 Rack and Hardware Install Guide
24
Revision 1
http://docs.fortinet.com/
•
Feedback
Figure 1: Removing and Installing a Hard Drive Blank
Installing a Hard-Drive Blank
Align the hard-drive blank with the drive bay and insert the blank into the drive bay until the
release lever clicks into place.
Removing a Hot-Swap Hard Drive
1
If present, remove the front bezel. See
“Installing the Bezel” on page 18
.
2
From the RAID management software, prepare the drive for removal. Wait until the
hard-drive indicators on the drive carrier signal that the drive can be removed safely.
See your SAS RAID controller documentation for information about hot-swap drive
removal.
If the drive has been online, the green activity/fault indicator will flash as the drive is
powered down. When the drive indicators are off, the drive is ready for removal.
3
Press the button on the front of the drive carrier and open the drive carrier release
handle to release the drive. See Figure 2.
4
Slide the hard drive out until it is free of the drive bay.
5
Insert a drive blank in the vacated drive bay. See
“Installing a Hard-Drive Blank”
.
6
If applicable, install the bezel. See
“Installing the Bezel” on page 18
.
Installing a Hot-Swap Hard Drive
1
3.5-in hard drive blank
2
2.5-in hard drive blank
3
release latch
3
1
2
3
Caution:
Ensure that your operating system supports hot-swap drive removal and
installation. See the documentation provided with your operating system for more
information.
Caution:
When installing a hard drive, ensure that the adjacent drives are fully installed.
Inserting a hard-drive carrier and attempting to lock its handle next to a partially installed
carrier can damage the partially installed carrier's shield spring and make it unusable.
