STEP 6
Exit the vehicle and close all of the doors.
The Remote-Starter will stop running once all the doors are
closed.
METHOD 2 This method must be programmed by the installer during installation. THIS METHOD WILL ACTI-
VATE THE REMOTE STARTER SEQUENCE EVERYTIME THE END USER IS LEAVING THE VEHICLE. AUTOMATIC AC-
TIVATION:
The vehicle must be running.
STEP 1
Make sure the transmission is in the NEUTRAL position.
STEP 2
Engage the parking brake.
STEP 3
Release the brake pedal.
STEP 4
OFF
Remove the key from the ignition barrel. The engine will shut down
and the vehicle will be ready to start at any time.
STEP 5
Exit the vehicle and close all of the doors.
The Remote-Starter will stop running once all the doors are closed.
The vehicle is ready to start. Open any door to cancel Ready Mode and start over the sequence from step 1
.
TO DEACTIVATE READY MODE:
•
Open any door(s) • Open the hood • Disengage of the parking brake
Note : If the parking lights fl ash 3 times when Remote-Starting, Ready Mode is not enabled.
DRIVING OFF
When the vehicle is running with the Remote-Starter, enter the vehicle and proceed with the following
steps:
STEP 1
IGN
START
OFF
Insert the key and turn it to the ignition (ON/Run) position.
Warning: Do not turn the key to the START position when the engine is
running. This may damage the ignition system on some vehicles.
STEP 2
Step on the brake pedal to disable the Remote-Starter, and put the vehicle
in gear.
CANCELLING A REMOTE START
See USING THE REMOTE CONTROL, page 4
REMOTE-STARTER FEATURES
IDLE MODE (AUTOMATIC TRANSMISSION)
Idle Mode allows the vehicle to run without the key in the ignition barrel. For example, if you stop for a
quick errand or delivery, simply allow the vehicle to run while you are gone. The engine will run until the
Remote-Starter runtime expires. Press START any time the vehicle is running with the Remote-Starter
Page 7 / 14