FORTEZA FORTEZA-300, User Manual

Page: 3 / 24

3
1. INTRODUCTION
1.1. The user manual contains information about the operation of the microwave
sensors «FORTEZA-300», «FORTEZA-500», «FORTEZA-300T», «FORTEZA-
500T» (below the sensor). There is the information required for the correct
operation (use, transportation, storage and maintenance) of the sensor.
The following abbreviations are used in this document:
Tx
- transmitter
Rx - receiver
MK - mounting kit
PSU - power supply init
JB - junction box.
2. PURPOSE
2.1 . The purpose of the sensor is to protect the perimeter sectors and to detect an
intruder crossing at his full height or bent (crawling) this sector.
2.2. The sensor is intended for continuous round-the-clock outdoor operation at an
ambient temperature:
«FORTEZA-300», «FORTEZA-500» from -45˚up to+65˚C
«FORTEZA-300T», «FORTEZA-500T» from -50˚ up to +60˚C
and relative humidity up to 98% at the tempe35

С.
3. SPECIFICATIONS
3.1. There are four modifications of the sensor: «FORTEZA-300», «FORTEZA-300T»,
«FORTEZA-500» and «FORTEZA-500T».
The recommended length of a sector for modifications:
«FORTEZA-300», «FORTEZA-300T» – from 10 up to 300m
«FORTEZA-500», «FORTEZA-500T» – from 10 up to 500m.
3.2. The detection zone height generated by the sensor at the maximum detection zone
length is not less than 1,8 m in the center of the protected sector.
3.3. The detection zone width in the center of the protected sector depends on the sector
length (Table 3.1.)
The detection zone is a volumetric part of the protected sector, within the scope of
which any movements of an intruder generate an alarm.