Forno FDRBI1876-30S, Instruction Manual

Page: 5 / 13

EN 4
given supervision or instruction concerning use of the appliance by person responsible for their
safety.
INSTALLATION INSTRUCTIONS
Before Using Your Freezer
•
Remove the exterior and interior packing.
• Leave the refrigerator in an upright position for at least 4-6 hours before you connect it to the mains.
This will reduce the possibility of a malfunction in the cooling system from improper handling during
transportation.
•
Clean the interior surface with lukewarm water using a soft cloth. (Refer to Cleaning instruction section)
• Install the handles on the drawers. (Refer to Installing The Handle section)
•
It is recomended that you install the unit in a place where the ambient temperature is between
50°F(10°C) and 109.4°F(43°C). If the ambient temperature is above or below recommended
temperatures, the performance of the unit may be affected. For example, placing your unit in extremely
colod or hot conditions may cause interior temperatures to fluctuate. The operating temperature range
may not be reached.
Check to make sure you have all the parts in accessory list.
Site Preparation
1. Position the unit on a flat, level surface capable of supporting the entire weight of the unit. The unit will
be significantly heavier once it is fully loaded.
2. Avoid connecting the unit to a Ground Fault Interruptor(GFI). GFI are prone to nuisance tripping which
will cause the unit to shut down. GFIs are generally not used on circuits which power equipment that
must run unattended for long periods of time.
3. The unit must be installed according to your local codes and ordinances.
4. Position the unit to allow free air flow through the ventilation grill at the bottom in the front.
Exhaust Intake
5. Wipe out inside of unit with a damp cloth.
6. Be sure to install the Anti-Tip bracket. Follow the instructions provided with the Anti-Tip bracket kit.
The Anti-Tip kit mut be installed on this unit before it is used. Double stacking units may
cause serious personal injury.
Anti-Tip Bracket Installation

WARNING

To avoid the risk of serious personal injury or damage to the appliance due to the
instability of the appliance, it must be fixed to the floor with anti-tip brackets and screws (supplied). Before
installing, carefully read these instructions.
A. Take the fixing brackets (2pcs) and screws (2pcs) out of the instruction packet.
B. Drill holes into the floor according to the dimensions shown below. This will allow you to fix the brackets
to the floor.
According to size and location, the hole punched on the floor should be Ø5/16".