3
WWW.FORNEYIND.COM
BATTERY STATUS
Press and hold the battery level status button. The battery level status button indicator LEDs will illuminate
to indicate the amount of charge remaining in the jump start system. When you release the button, the LED
indicator lights will go out.
• A red light indicates a 50% or less charge and you should immediately recharge the jump start.
• A yellow light indicates a 50% to 75% charge. The jump start may be used but should be recharged as soon
as possible.
• A green light indicates the internal battery is fully charged.
JUMP STARTING A BATTERY
• This unit should only be used on vehicles with 12 volt DC battery systems.
• Never attempt to jump start a frozen battery.
• Make sure that the vehicle’s accessories are turned off (lights, AC, heater, radio, etc.)
• Securely connect the red positive (+) booster clamp to the corresponding positive (+) terminal of your vehicle’s battery.
• Then securely connect the black negative (–) booster clamp to an unpainted, non-moving part of the chassis or
engine block. Do not connect directly to the negative battery terminal.
• Start your vehicle. Once the vehicle has started, disconnect the black negative clamp first and then the red
positive clamp.
NOTE:
If your vehicle does not start within 10 seconds, allow the jump start system internal battery to cool for 3
minutes before attempting to start the vehicle again.
POWER FOR YOUR 12 VOLT ACCESSORIES
The 12 volt power port will operate most 12 volt accessories. It has a 15 amp automatic overload protection
circuit breaker. Reset the breaker by pushing the breaker button located on the back of the jump start.
LOCATION OF CONTROLS
1. AC/DC Charging Port
2. Charging Indicator
3. Battery Level Status Button
4. Battery Level Indicator LEDs
5. Booster Clamps
6. Circuit Breaker (back)
7. 12 Volt Power Port (back)
2
3
5
4
1
