21
WWW.FORNEYIND.COM
Welding Tips:
•
Always weld clean, dry and well-prepared material.
•
Hold torch at a 45° angle to the workpiece with nozzle about 1/2” from the surface.
•
Move the torch smoothly and steadily as you weld.
•
Avoid welding in very drafty areas. A weak, pitted and porous weld will result due to drafts blowing away the
protective welding gas.
•
Keep wire and liner clean. Do not use rusty wire.
•
Sharp bends or kinks in the welding cable should be avoided.
This machines has a 7-pin Amphenol™ style connection for connecting accessories like spool gun, foot pedal, and
amperage controlled TIG torch.
•
Spool Gun (trims WFS) – attach spool gun to Euro style MIG torch connection and then plug in 7-pin connector.
•
Double check the MIG process is selected.
•
Set correct WFS on machine.
•
Use trim wheel potentiometer on spool gun to fine adjust WFS up or down by 10% as needed.
•
Foot Pedal (adjusts amperage) – attach TIG torch to negative Dinse™ terminal and then plug in 7-pin foot
pedal connector.
•
Double check the TIG process is selected.
•
Set desired maximum current on the machine.
•
Use pedal to fine control amperage.
•
Amperage controlled TIG torch – attach TIG torch to negative Dinse™ terminal and then plug in 7-pin
connector.
•
Double check the TIG process is selected.
•
Set desired maximum current on the machine.
•
Use roller wheel on the TIG torch to fine control amperage.
Additional Machine Accessories
220 MP TIG SET-UP CHART
TIG
(GTAW)
Polarity
Material
Thickness
1/16" (1.6mm)
3/32" (2.4mm)
1/8" (3.2mm)
3/16" (4.8mm)
DCEN
DCEN
-Recommend
2%
Certiated
Tungsten
Filler
Diameter
Amperage
Gas
Cup
Tungsten
Diam
Filler
Diameter
Amperage
Gas
Cup
Tungsten
Diam
Filler
Diameter
Amperage
Gas
Cup
Tungsten
Diam
Filler
Diameter
Amperage
Gas
Cup
Tungsten
Diam
100%
Argon
1/16"
(1.6mm)
50-80
3/8"
(#6)
1/16"
(1.6mm)
1/16"
(1.6mm)
80-110
3/8"
(#6)
1/16"
(1.6mm)
3/32"
(2.4mm)
85-120
3/8"
(#6)
1/16:
(1.6mm)
1/8"
(3.2mm)
125-200
7/16"
(#7)
3/32"
(2.4mm)