FORM FIT
HOOD PROTECTOR
Acura RDX 2007 -
HD 1H 07
HARDWARE KIT
TOOLS REQUIRED
4 – Large Bumpons
1 – Grease Pencil
1
–
Tape
Measure
1 – Screwdriver #2
1 – 32” x 3/8” Roll Gasket
1 – Alcohol Wiping Pad
4 – Expansion Plugs
4 – #6 x ½“ Screws
INSTALLATION
1. Be sure that the hood is clean and dry inside and out. Release the hood, but do not open it.
2. Install the four (4) bumpons as shown.
NOTE:
The bumpons must be installed on the hood not on the protector. If the bumpons are installed on the protector, they will
wear through the hood paint.
200mm
440mm
45mm
100mm
3. Open the hood of the vehicle
4. Wipe the bottom of the hood edge trim where the protective gasket will attach, with the alcohol pad provided.
5. Measure and mark 70mm in from where the hood edge trims starts. Peel the protective backing from the roll of gasket
material, and attach it to the edge trim at this point as shown
below.
Hood
Hood Edge Trim
Protector
70mm 70mm
*
Protective Gasket Placement
