FORGE ADOUR MODERN G45, Manual

Page: 10 / 16

24
To ensure safe use of your FORGE ADOUR
plancha, it is essential to comply with the
different rules for installation and use below:
•Remember to remove the protective
adhesive film from the stainless steel parts.
•Between use, be sure to close the gas bottle
valve or the wall valve in the case of natural
gas supply.
•For use indoors, be sure to keep a distance
of 17 cm between your appliance and
the vertical partitions surrounding your
appliance (recess).
•Do not store or use flammable products or
vapours near the plancha.
•If there is a smell of gas, close the gas
bottle valve or the wall valve in the case of
natural gas supply.
•If the appliance is placed on a support
(table, etc.), it must imperatively be fitted
with its 4 legs.
•It is strictly prohibited to use your FORGE
ADOUR plancha on a unit with wheels when
used with natural gas.
•Your FORGE ADOUR plancha is not
connected to a combustion product discharge
system. It must be installed and connected
in accordance with the installation rules
in force. Particular attention shall be paid
to the applicable provisions regarding
ventilation. A 15 m3/h fresh air flow is to be
provided for the combustion air supply.
•Warning: some accessible parts may be
very hot. Keep young children away.
•Do not move the appliance while in
operation.
•Do not use an adjustable pressure relief
valve.
•Allow the plancha to cool before cleaning
the chassis and handling the grease tray.
•Make sure that the hose is not in contact
with the hot parts of the appliance.
•If your appliance is protected by a soft
cover, be sure to remove it completely before
using the plancha.
•If your plancha is equipped with a lid, make
sure that this lid is in the “OPEN” position
while heating and in use.
•For use without a FORGE ADOUR wheeled
unit or support: the gas bottle (13 kg) which
supplies the plancha must be placed 80 cm
away from the appliance.
•If the plancha is to be used on a wheeled
unit or support, it is essential to use a bottle
weighing 6 kg max.
•Warning: tightness is to be checked
outdoors, away from any source of ignition.
•Make sure that the control switches are in
the closed position. After opening the bottle
and resetting the pressure relief valve, check
that there are no bubbles on all fittings,
on the pressure relief valve and on the
appliance, using soapy water.
The presence of bubbles indicates a leak.
Close the gas bottle and tighten all the
fittings.
Repeat the tightness test. If the leak comes
from the appliance, do not use your plancha
and contact the manufacturer or the retailer.
Test the tightness every time the bottle is
replaced.
Danger: never test the tightness of your
appliance with a flame. Never use a leaking
appliance.
Precautions for use
https://www.kipogeorgiki.gr/