885mm
4
Screw the central boards to the fascia boards.
Ensure each one is
885mm from the inner face of the fascia board
shown above.
As a result, there will be an 80mm space between the central boards. Ensure the top edge is flush to the top edge of the fascia
boards
.
60
MM
SCREWS
Attach the additional batten to the central board
(one for each board).
Ensure the bottom face of the batten is flush to the
bottom face of the central boards.
Secure with 4 x screws at each side shown above.
Place
and
screw
t
hrough the panel frame
and into the fascia
to secure.
Repeat
for both panels.
5
80mm
100
MM
SCREWS
60
MM
SCREWS
STABILITY
We
strongly advise
that you
anchor
your pergola down with either fixture examples shown below to
enhance stability.
You will need to
purchase these separately.
Apply each fixture to each leg after fully constructing your pergola. These are just two examples of many, that you
could use to anchor your pergola.
FOR PATIO/DECKING (HARD SURFACES)
Screw a ‘heavy duty’ bracket to each post and to
the floor to secure.
FOR GRASS/SOIL (SOFT SURFACES)
Screw the a ‘heavy duty’ bracket to each post and
use a ‘hex peg’ or similar type of fixing to anchor
the bracket into the ground.
CENTRAL BOARD
SUPPORT BATTEN
SLATTED PANEL
