FOREST SHUTTLE
®
S/M/L RECEIVER
7
EN
DE
FR
NL
SPEED (1 & 2):
Standard speed is 14cm/s. For faster speed, 17cm/s, press 2x button. To confirm, press and hold
once more for 4 seconds until the led blinks 3 times and goes OFF.
PROGRAMMING RF REMOTE CONTROL / CHANNEL (3):
To program a RF remote to a Shuttle
®
, press configuration button 3 times. LED3 is ON. Press
and hold once more for 4 seconds, LED will start blinking for 10 seconds. In these 10 seconds
press OPEN button on remote to program the channel to the Shuttle
®
. Same procedure, but
press CLOSE instead of OPEN, will erase the programmed channel. Adding another channel, or
another remote, can be done by pressing the P button 2 times, switch to new channel/remote
and press the OPEN button once. Now the new channel/remote will also control the Shuttle
®
.
COPYING OF PROGRAMMED RF REMOTE CONTROL
If you want to use several remote controls for the same motors, you can easily copy already
programmed remote controls. Press the P button twice on the back of the remote control. Switch
to the channel on the extra remote control and press the OPEN button. The channel settings
have now been copied to the extra remote control.
RESET END LIMITS (4):
For resetting only the end limits: press button 4x. To confirm, press and hold once more for 4
seconds until the led blinks 3 times and goes OFF. When a Forest remote is programmed to the
Shuttle
®
, the end limits can also be reset by pressing 5 times the P button and 5 times the STOP
button on the remote. End limits of all Shuttles
®
in range on this channel will reset end limits.
DRY CONTACT INPUTS (5, 6 & 7):
Standard input is pulse contact. To set to continuous or single switch, press button 6 or 7 times
respectively. To confirm, press and hold once more for 4 seconds until the led blinks 3 times and
goes OFF. Please see page 8 for detailed explanation. Make sure the contact is free of potential.
TOUCH IMPULSE (8, 9 & 10):
The Shuttle
®
recognizes when the curtain is pulled by hand to open or close. The Shuttle
®
will
then open or close the curtain all the way. Default setting is high sensitive. Touch Impulse can be
set to less sensitive or off, with 9 or 10 presses respectively. To confirm, press and hold once more
for 4 seconds until the led blinks 3 times and goes OFF.
IR CHANNEL SETTING (11, 12, 13, 14 & 15):
For Infra Red control an IR remote and an IR receiver is required, connected to port 1. Place the
eye of the receiver cord in view of the IR remote. Standard the Shuttle
®
is set to channel 1 and
‘ALL’. To change to channel 2, 3, 4 or 5, press resp. 12x, 13x, 14x or 15x button. Press and hold
once more for 4 seconds until the led blinks 3 times and goes OFF.
FACTORY DEFAULT (16)
To reset all settings, press button 16x. To confirm, press and hold once more for 4 seconds until
the led blinks 3 times and goes OFF.
