Forest Master Model: FM6DD-MUL/FM6DDES-MUL/FM4DDE-MUL
17
Changing the Feed and Discharge Angles
To slow down or speed up the feed rate, or to alter the discharge angle, the drum
housing can be rotated to change the angle of the feed hopper and the discharge
chute. The drum housing can be rotated by a maximum of 40 degrees.
Note however that for CE regulation compliance, the exit of the discharge chute
should be no more than 30mm from the ground. The chipper is shipped with the
drum set at the correct position to comply with this.
Operation
Loosen the 3 nuts shown, just
sufficiently until the drum housing
is free to rotate. DO NOT remove the
nuts.
Rotate the drum housing to the
required angle then tighten the nuts.
The square shoulder of the coach
bolts must remain located in the slots
in the back plate.
Maximum Hopper Angle
CE Position
Minimum Hopper Angle
