1
3
35mm
5
4
T
P
O
H
N
Fix two hinges to each of the doors using the smaller plate of the hinge as shown and (4.0 x 30mm)
screws. Place the doors in to the entrance and secure the other half of the hinge to the entrance
framework.
Make sure there is enough clearance around the doors so that they can move freely.
Fix a corner brace to each end of the 1800 batten (T) on the 28mm side. Make sure that it is positioned as
shown and is 35mm from the end. Fix in place using
2 x (3.5 x 30mm)
screws for each.
Place the batten at the apex so that it sits on the blocks on the front and back panel. Use
2 x (3.5 x 30mm)
screws to secure each of the corner braces to the blocks.
Place the panels on to the floor (E) as shown making sure that they are tight and flush. Fix the panels to
each other using
4x50mm
screws for each join.
Make sure that all four sides are square and fix them to the floor using 50mm screws. Use
4x50mm
screws for the door end (A) and Plain end (B). Use
3x50mm
screws for the sides (C) and (D).
Place each of the 1710mm strips (M) against the corners of
the building. Fix each in place using
3 x (3.5 x 30mm)
screws.
Position the veranda
(F) against the front of
the building as shown.
Fix this in place using
4 x 50mm screws,
screwing into the
bearer.
From inside the building fix the two 1785mm
strips (N) to the sides of the door, lining
them up so that they are flush on one side
and overhang the entrance slightly.
Fix each using
3 x (3.5 x 30mm)
screws.
Place the strips (O) and (P) above the
entrance as shown, again lining these up
with the top of the framework. There should
be a 46mm gap between the two strips.
Fix each in place using
2 x (3.5 x 30mm)
screws.
TOP VIEW
B
A
D
C
R
B
D
A
N
F
From outside of your
building fix a turn
button to the top and
bottom of the left hand
door using 2 x (4.0 x
30mm zinc) screws.
Make sure that the
turn button will reach
across both doors
when in its closed
position.
2
Place the window (L) into the door end so that there is an equal gap each side before placing an 848mm
(R) (
rebated
) batten on either side. The rebate should sit against the window.
Fix each batten in place using 3 x 50mm screws screwing into the door ends framework.
M