8
7. Attach door (I) to upper beam (L) and bottom beam (H) with bolt (AA) and washer (BB) using hex screw driver
(CC), (see Figure 7).
NOTE:
DO NOT tighten the screws completely.
Hardware Used:
AA Bolt (M6 x 15) x 2
BB Washer (M6) x 2
CC Hex screw driver x 1
Hardware Used:
DD Bolt (M4 x 25) x 1
9. Place table top (B) on a non-abrasive flat surface to prevent scratching. Attach base assembly to table top
assembly (B) with bolts (AA) and washers (BB) using hex screw driver (CC). Make sure the control panel just
covers up the notch on the right panel (E), (see Figure 9).
NOTE:
Tighten ALL screws completely.
Hardware Used:
AA Bolt (M6 x 15) x 4
BB Washer (M6) x 4
CC Hex screw driver x 1
8. Attach door handle (O) with bolt (DD), then use Phillips screw driver (not included) to screw tightly (see
Figure 8).
NOTE:
DO NOT tighten the other screws completely.
CC
AA
BB
CC
AA
BB
BB
Figure 8
Figure 9
Figure 7
O
DD
L
H
B
E
control panel
