Ford TOURNEO CONNECT, Owner'S Manual, Page: 302 / 437

Fig. 177 Changing the bulbs in the turn signal
repeater.
The actions should only be carried out in
the specified order:
1. Observe and follow the instructions in
the checklist → page 296.
2. Push the turn signal repeater in direc-
tion of travel and swing it out at the rear
→
Fig. 176 .
3. Lever the turn signal repeater out of the
body.
4. Turn the bulb holder in the direction of
the arrow and pull the bulb rearwards
out of the housing
→
Fig. 177 .
5. Pull the bulb straight out of the bulb
holder.
6. Replace the defective bulb with a new
bulb of the same type.
7. Insert the bulb holder into the housing
and turn it as far as it will go in the op-
posite direction to the arrow
→ Fig. 177 .
8. Fit the spring clip of the turn signal re-
peater at front into the body, push it
against the spring force in direction of
travel, and engage it at the rear into the
body.
Changing fuses
Introduction
At the time of publication we are unable to
provide an complete overview of the loca-
tions of the fuses for the electrical consum-
ers. This is because the vehicle is under
constant development, because fuses are
assigned
differently depending on the vehi-
cle equipment level and because several
electrical consumers may use a single fuse.
You can get more information about the
fuse layout from an authorised dealer.
Several pieces of electrical equipment can
share a single fuse. Conversely, a single
consumer could have more than one fuse.
Therefore fuses should only be replaced
when the cause of the fault has been recti-
fied. If a new fuse blows again shortly after
fitting, have the electrical system checked
by a suitably qualified workshop as soon as
possible.
WARNING
High voltages in the electrical system can
cause electric shocks, serious burns and
death.
·
Never touch the electrical wiring of the
ignition system.
·
Avoid causing short circuits in the elec-
trical system.
WARNING
Using unsuitable or repaired fuses and
bridging an electrical circuit without fuses
can cause a fire and serious injuries.
·
Never fit fuses that have a higher fuse
protection limit.
·
Replace fuses only with fuses with the
same rating and size. Make sure that
the colour and markings are identical to
the defective fuse.
·
Never repair fuses.
·
Never use a metal strip, paper clip or
similar objects to replace a fuse.
NOTICE
To avoid damage to the electrical system in
the vehicle, switch
off the ignition, the lights
and all electrical consumers before chang-
ing a fuse.
·
Make sure that it is not possible to switch
on the ignition when changing a fuse.
300 If and when