FX1-1050
EN
Copyright © 2015
P a g e
|
8
www.Ford-tools.com
8.2
Dismantling
Proceed in reverse order to mounting
WARNING Accessories can be hot after use. Don
’
t touch the
tip of accessory by hand! Please always use protective gloves
to remove the accessory.
8.3
Additional handle (fig; 4)
For safety reasons you must only use the demolition hammer
with the additional handle.
The additional handle (1) enables you to achieve better stability while using
the demolition hammer.
The additional handle can be turned into any required position. To do so, undo
the lock knob (8) of auxiliary handle. Then turn the handle into the most
comfortable working position and tighten the lock knob (8) again.
Important. To avoid danger, the machine must only be held
using the two handles (2-3). Otherwise you may suffer an
electric shock if you chisel into cables.
9
LUBRICATION - OIL LEVEL
Check the oil level before using the machine.
Place the machine on the floor with the tool chuck (5), pointing downwards.
The oil must be at least 3 mm above the bottom of the inspection window (6).
The oil should be changed after around 40-50 hours of use.
Recommended oil: 25ml SAE 15W/40 or an alternative of the same quality.
9.1
Oil change (Fig. 5)
Switch off the machine and disconnect the plug from the socket.
Undo the hexagonal head screw with the inspection window (6) using the
wrench (7) and drain the oil.
To prevent the oil from running out in an uncontrolled manner, hold a small
metal chute under the opening and collect the oil in a vessel until it has fully
drained out of the machine.
Important: The waste oil must be disposed of in the
appropriate collection point for waste oil.
Add new oil (approx. 25 ml) through the oil filler opening until the oil level
reaches the required level. Tighten the hexagonal screw again.
Re-check the oil level after a short period of operation.
