CAUTION!
19
MAINTENANCE
High Pressure Hose
•
Inspect hose for cuts, bulges, or leaks which can develop from kinking or wear. If damage is found, immediately replace
hose.
•
Inspect couplings for damage. Immediately replace hose if damage is found.
Spray Gun
•
Make sure the spray gun is connected securely.
•
Inspect the spray gun safety and make sure the spray gun trigger springs back upon release.
Spray Nozzle
If a pulsing sensation is felt while squeezing the trigger, the spray nozzle may be dirty or clogged and should be cleaned
immediately.
•
To clean the nozzle, shut off the engine and turn off the water.
•
Remove the nozzle from the spray wand making sure that the nozzle is pointing away from you and in a safe direction.
•
Use the nozzle cleaner or a small paper clip to dislodge any foreign materials which are clogging or restricting the
spray tip.
Never repair high pressure hose or use unit if hose is damaged. If hose is damaged replace
with identical Pulsar part.
WARNING!
Changing Engine Oil
Engine oil will drain better if the engine is still warm, but not hot.
•
Shut off engine.
•
•
Place an oil pan on the ground to catch oil. Remove oil plug then tilt pressure washer back and to the side to empty out
the oil from the crankcase.
Oil Drain Plug
•
Once oil is completely drained, return the pressure washer to a level position and install the oil drain plug. Refill the
engine with new oil as instructed earlier in this manual under Adding/Checking Oil.
Clean the area around the oil fill cap/dipstick to keep out debris then remove oil fill cap/dipstick.
Checking Detergent Siphoning Tube
•
Check the detergent siphoning tube for clogs, leaks, or tears.
Make sure the tube fits tightly to the pump fitting.
•
•
Replace siphoning tubes if damaged.
Risk of injury. If the pressure washer is equipped with a battery, disconnect the battery
ground wire before servicing.
Summary of Contents for FPWG3100H-J
Page 8: ...8 PRESSURE WASHER PARTS ASSEMBLY...
Page 24: ......
