19
OPERATION
ON
OFF
Stopping Pressure Washer (See Fig 13)
• Turn the on/stop switch to the OFF position.
• Turn the fuel valve to the OFF position.
• Turn off water and squeeze the trigger handle to release all
water pressure.
FIG 13
• Always relieve pressure from spray gun before pulling starter cord, including every failed attempt to start engine.
• To avoid recoil, pull starter cord slowly until resistance is felt, then pull rapidly.
WARNING!
Pull cord recoils rapidly and pulls arm towards engine faster than you can let go which
could result in injury.
Using the Spray Gun (See Fig 14 - 15)
• Flip the lock tab behind the trigger up or down until it clicks to apply or remove the safety. Pull back on the trigger to
To stop water flow, release trigger.
begin operating pressure washer.
•
FIG 14
FIG 15
TRIGGER
SLOT
LOCK OUT
Know how to stop the product and bleed pressures quickly. Be thoroughly familiar with
the controls.
This pressure washer is equipped with a thermal relief valve (TRV). The TRV is a temperature actuated valve that will
open and allow cool water to pass from the garden hose through the pump head to cool the head if the pump reaches
140°F. The water will flow from the garden hose through the head and discharge from the pump to the ground through the
TRV elbow. The TRV elbow must always be facing downward to allow the heated water to spray toward the ground. This
valve will open if the unit is left running for several minutes without squeezing the trigger of the spray gun. Spraying the gun
allows the pump to cool by passing fresh cool water from the garden hose though the pump head.
Risk of Injection or Injury – Do Not Direct Discharge Stream At Persons.
WARNING!
