14
ASSEMBLY
• Parts needed - 2 hair pins, 2 wheels, 2 axles, 2 hub caps and 2 self-tapping screws.
• Slide the wheel axle pin through hole located in the center of the wheel.
• Raise or tilt pressure washer so you can slide the wheel axle pin into the wheel mounting hole located on the side of
the frame.
• Secure the wheel assembly by reinserting a hair pin through hole at the end of the wheel axle and pressing until it locks
into place.
• Install the hub cap to the wheel until “Click” and install the self-tapping screw, until the screw is snug.
• Repeat process on the other side of the pressure washer to install the second wheel.
Attaching Wheel Assembly (See fig 1)
• Parts needed - 2 foot, 2 M8 lock nuts.
• Raise or tilt pressure washer so you can line up foot with the hole located at the side of the frame opposite the wheel.
• Align the rubber foot with the hole in the frame where the foot is to be located. Attach foot by inserting the bolt from the
bottom up and install the acorn nut. Wrench tighten until there is a slight crush on the frame tube. (Do not over tighten)
Attaching Foot Assembly (See fig 1)
Raising Handle (See fig 2)
• Raise the handle, then screw the thumb knob nut until it is snug.
FIG 2
FIG 1
90°
